- INTERSEAL offers extensive customisation possibilities to make hydraulic manifolds fit into every single project or machine.
- In addition to extensive customisation possibilities for hydraulic manifolds, INTERSEAL also offers the option of having these hydraulic manifolds comply with the specifications required by international certifying bodies. The manifolds can also be supplied with such certification.
INTERSEAL offers extensive customisation possibilities to make hydraulic power packs fit into every single project or machine.
Bonded seal seals, Bonded seal seals, NBR, FKM, in steel and stainless steel.
OP double-acting seal, Double-acting seal for rod and piston. Polyurethane Hardness: 93 Shore
PFS static seal, Static seal for SAE polyurethane fastener Hardness: 93 Shore A
O-rings, O-rings, NBR 70/90 Sh. -30ºC+ 110ºC, Silicone MQ -60ºC + 230ºC, Viton FKM -20ºC + 200ºC.
Q-ring seal, Four-lip square seal, Nitrile rubber NBR Hardness: 70 Shore
Cord ring, Cord ring by the metre. NBR 70 Sh. A -30ºC +110ºC. Silicone MQ -60ºC + 230ºC Viton FKM -20ºC + 200 º C
FIMBU bushing, Filled PTFE base, sintered CuSn8 bronze coating, low-carbon steel support.
FIMBX bushing, Low-carbon support with porous and sintered sliding coating, which is in turn impregnated with a resin-acetal coating.
FINBW-BRM bushing, The bearings of the BRM-10 series are made entirely of CuSn8 bronze.
VA, VA profile Standard design. Available in the widest range of materials and measurements (from Ø9.5 up to Ø2.020 mm).
VS, VS profile The lip is exactly the same as in the VA, but the housing is more robust. As standard as the previous one, but in a smaller measurement range (up to Ø210 mm.)
VL, VL profile Geometrically similar design to the VA but with reduced cross-section for small housings. Manufactured in a single section ranging from Ø135 up to Ø410 mm.
RB, The design of the RB seal is based on many years of experience in this type of applications, NBR OR FKM.