OP double-acting seal, Double-acting seal for rod and piston. Polyurethane Hardness: 93 Shore

PFS static seal, Static seal for SAE polyurethane fastener Hardness: 93 Shore A

O-rings, O-rings, NBR 70/90 Sh. -30ºC+ 110ºC, Silicone MQ -60ºC + 230ºC, Viton FKM -20ºC + 200ºC.

Q-ring seal, Four-lip square seal, Nitrile rubber NBR Hardness: 70 Shore

Cord ring, Cord ring by the metre. NBR 70 Sh. A -30ºC +110ºC. Silicone MQ -60ºC + 230ºC Viton FKM -20ºC + 200 º C

SC type

Single-lip seal manufactured according to DIN 3760 standard. The exterior is rubber-coated to increase the sealing ability with the pocket.

TC type

Double-lip seal manufactured according to DIN 3760 standard. The anti-dust lip design protects from external contamination. The exterior is rubber-coated for increased sealability with the pocket.

SB type

Single-lip seal. The exterior is finished in sheet metal. Designed to absorb temperature and facilitate assembly. Manufactured according to DIN 3760 standard with phosphate coated sheet.

TB type

Double-lip seal. The exterior is finished in sheet metal. Designed to withstand temperatures and facilitate assembly. Manufactured according to DIN 3760 standard with phosphate coated sheet, with anti-dust lip.

SA type

Single-lip seal. The exterior is finished in sheet metal and reinforced. Designed to withstand temperatures, heavy loads and dirtier environments, and facilitate assembly.

TA type

Single-lip seal. The exterior is finished in sheet metal and reinforced. Designed to withstand temperatures, heavy loads and dirtier environments, and facilitate assembly, with anti-dust lip.

TCN type

Double-lip, special construction seal to withstand pressures up to 11 bars. The exterior is rubber-coated to increase the sealing ability with the pocket.

DC type

Working double-lip seal with two springs. Designed to separate two fluids. Great sealing power for double sealing. Commonly used in water pumps and crankcases to separate two fluids.

VG type

Shutter-type springless single-lip seal with ribbed outer lip. Specifically designed to protect against external contamination. The outer ribbing facilitates assembly and absorbs temperature expansion.

Exterior fastening covers. With various specifications (RCA, END CAPS, CAPELLOTI) manufactured for the end-of-stroke fastening of reducers. They can be manufactured in various materials, such as FPM, NBR, VMQ, VMQ.

VA, VA profile Standard design. Available in the widest range of materials and measurements (from Ø9.5 up to Ø2.020 mm).

VS, VS profile The lip is exactly the same as in the VA, but the housing is more robust. As standard as the previous one, but in a smaller measurement range (up to Ø210 mm.)

VL, VL profile Geometrically similar design to the VA but with reduced cross-section for small housings. Manufactured in a single section ranging from Ø135 up to Ø410 mm.

RB, The design of the RB seal is based on many years of experience in this type of applications, NBR OR FKM.